Reliable Supplier Blood Pressure Monitor Bluetooth - ICU electric hospital bed DHC-III(FM04) – VinnieVincent

1. Specification:
Overall dimension: L2170 × W1080 × H440/800mm，
Bed panel: L1950 × W910mm；
2. Function: the overall lifting is 440 ~ 800mm, the back plate is adjusted by 65 ° ± 5 °, the leg is adjusted by 45 ° ± 5 °, the lower leg plate is adjustable in two sections, and the fore-and-aft inclination is 13 ° ± 3 °;
3. Bed frame: 60 * 30 * 3.0mm high-quality cold drawn rectangular tube is used as the girder, and 60 * 30 * 3.0mm high-quality cold drawn rectangular tube is welded with rungs at both ends. It can fully ensure the bearing capacity of the bed ≥ 240kg;
4. Bed surface: high quality anti Beite bed board, with X-ray transmission throughout the body; It has the characteristics of good anti-corrosion, acid and alkali resistance and various chemical reagents; The back plate is equipped with a film cassette to realize X-ray photography of the patient’s upper body in the bed;
5. Bed body: it is made of Dutch Akzo Nobel environmental protection antibacterial powder by electrostatic spraying, which can prevent Staphylococcus cross infection, and has the characteristics of anti-corrosion, rust prevention and exquisite appearance; With extended bed frame, the extended bed board can reach 2350mm;
6. Headboard and tailboard: made of high-quality and drug-resistant PE resin, blow molded as a whole, with skin texture treatment on the surface, easy to clean and arc-shaped design. The outside of the head and tail of the bed is equipped with anti-collision angle wheels, which can be replaced separately, which can effectively prevent the hospital bed from colliding with the wall during movement. The four anti-collision angles are equipped with oxygen cylinder bracket hanging holes (see Annex). The bed tail board has a transparent acrylic patient information card slot;
7. Guardrail: the new American guardrail made of high-quality PE material is blow molded as a whole. Each guardrail is equipped with a damper device to control speed and noise. It is firm, durable, fast and light. The guardrail design meets the requirements of IEC safety regulations, beautiful, generous and safe; The front and rear guardrails are equipped with ball angle display, which can clearly display the rising angle of the bed board of the back and legs and the inclination angle of the bed body. A 30 degree scale mark is required to be set on the guardrail to clarify the angle at which the back rises by 30 degrees, which can effectively assist clinical VAP pneumonia;
9. Casters: imported double-sided casters with a diameter of 125mm, with locking, free and directional three-stage central control locking device; High stability linkage system, silent, corrosion-resistant, large braking force, stable and safe;
10. Configuration: it is equipped with mattress skid arrester. There are five places on both sides of the back plate and at the foot of the bed, which can avoid the side sliding of the mattress and improve the safety. It is equipped with a fixed position of restraint belt, 3 on the left and 3 on the right;
11. CPR: the manual CPR operation wrench device on the left and right sides of the bed can realize rapid treatment and reduce medical accidents in case of emergency. One drainage hook on the left and right sides, with a load of ≥ 3kg;
12. Motor: timoshen medical motor is adopted, with stable speed control, low noise, long service life, safety and reliability. The guide rod system adopts high carbon steel and high-strength aluminum platform, and two-way pole overload protection screw rod;
13. Accessories: there are drip bar, power assisted lifting rod, oxygen bottle rack and other optional accessories.